This is the “Shop” page and it list all of the products we offer. All scales are listed here so be sure the item your looking at is the scale you want.
-
Out of stock
Budd Dome Car Window Insert HO 541-0001 -
Dome Car Window Insert for CZ dome cars. N Scale 541-1001
-
The Rix Rax Under-Layout Mounting Bracket -
Rix Rail-it HO Scale -
Rix Rail-it N Scale -
The Rix Rax Flat is designed to mount flat against the bottom of the layout, giving you more room under the layout. This photo shows a different approach to mounting the Rix Rax Flat. Instead of mounting it under the layout with the wire running up to the turnout, we mounted it on top next to the turnout. (in a staging yard) We ran the piano wire from the turnout to the top hole in the pivot arm. The fulcrum can still be used to adjust the throw.
628-0005 -
For controlling turnouts from underneath the layout by choke rod or switch machine. -
The Rix Ajusto Pad is designed to provide a place to mount a twin coil switch machine so that the machine can be adjusted after its mounted to the layout. -
The Rix Switch Stand works directly off the throw bar from any type turnout. Rotating target turns 90 degrees as the turnout moves. This is not a ground throw. The target only rotates when the turnout is operated by some other source. -
Rix Uncoupling Tool (HO) 628-0014 -
The Rix Rax 21 under layout mounting bracket for Hankscraft Display Motors. 628-0021 -
Out of stock
The Rix Twin Coil Switch Machine is a snap action type machine designed to throw most turnouts from above or below the layout. Momentary contact from a push-button is required to operate the machine. Power source should be a capacitor discharge unit or a 16 to 24 volt transformer, AC or DC. Includes D.P.D.T. set of contacts and mounting screws. -
Rix Rax 21 Replacement Arm (Includes: Stronger Arm and Wire) 628-0022 -
The Rix Pick Uncoupling Tool is Designed to work with the Kadee® style Couplers. Place the Rix Pick Uncoupling Tool down inside the knuckle and rotate which will cause the couplers to release. No, The box car is not included. Sorry. -
Rix Telephone Poles (30 & 40 foot poles (only) 36 Poles. -
Crossarms (only) 72 total. (36 crossarms shown) 628-0031 -
2 Arm Poles includes 18 poles and 36 Crossarms -
4 Arm Poles includes 12 Poles and 48 Crossarms -
40 Foot Poles (only) 36 total (Stock No. 628-0040) -
Out of stock
The Knob Kit is to be used to dress up rotary switches which are used around the layout or when building a CTC panel. 628-0061
-
The CTC Knob Only Kit is to be used to replace broken knobs. The knob spring insert is not included. 628-0062 -
The CTC Switch Plates. (2 each) This plate is reversible with Switch molded on one side and Signal molded on the other side. Decal sheet not included. 628-0063 -
Rix Highway Pier. HO -
Kit includes 1 50 foot overpass. Beams, Roadway Early Railing. (only) No pier. 628-0101
